During PC Boot-up process getting a message that says "Interface board or CD Rom drive is not ready". Then below that message another message reads "Insure that drive power is on and drive cables correctly attached".

What is the problem?

System specs, please.

------------------
mjc
Links list:Computer Links (http://www.fortunecity.com/skyscraper/highrise/11/index.htm)

Celts are the men that heaven made mad, For all their battles are merry and their songs are all sad.

Originally posted by mjc:
System specs, please.



P54/P55C, Cyrix M11 300 Processor, 32MB, Award Modular Bios V4.51PG, IDE Controller using IRQ14, Serial Bus Ctrl IRQ 11, Display Ctrl IRQ 10, Hard Drive 426MB Primary Master, Secondary Master Slave is CD Rom Mode 3. Device Driver ver 4.03 driver name MVCD001. Hopefully this helps.