I recently went to dl motherboard monitor 5
http://mbm.livewiredev.com/
at first i find it good.
i adjust the sensor for cpu motherboard and aux
howerver , it sense that my cpu temp was 24c on average it went way below 50c be4 installation.
One more thing was after i trying switching the sensor to c if i made a mistake, it went way up to 94c!!!!:mad:
i was scared :eek:
the 94c was detected by aida32 which was already installed and also the *********5 u noe.. :mad:
My CPU fan was spinning as i can hear it...like the first few seconds of booting up..
luckily, i immediately disable the ***********5 and uninstalled it, it went back to 50c
Can some1 tell mi wad went wrong:confused: coz i dun wanna make the same mistake:)

The problem is probably with the software, not with the hardware actually overheating. MBM5 is tricky to set up. You need to read the help/manual instructions to get it set up properly....

Is a 50c system cool enuf then:confused:
coz it cant get lower nor higher except to abt 53c

50C is a bit warm, but not enough to worry about. You could probably get it down a bit by using more fans, using a good thermal compound and possibly using a different heatsink/fan... You probably don't need to go that far though.