PDA

View Full Version : Modem commands?



4thandgoal
02-19-2001, 01:48 PM
Hello everyone,

I have an application, PCAnywhere, that is used to dial into a PPP connection. I do not have a problem dialing in, but sometimes I have a problem disconnecting. I close the program, but the application does not disconnect the modem from the PPP connection. Is it possible to use an AT command at the Dos 7 command line to disconnect the modem? If so what is the syntax? If memory serves me correct, the AT command to disconnect is ATH. Also, I would bet the command in volves MODE? I am running 95 OSR2.

[This message has been edited by 4thandgoal (edited 02-19-2001).]

Randy_tx
02-19-2001, 03:21 PM
There is not a command line or C prompt command you can use; however, you can go into "Hyper-Terminal"(accessories/communications) mode and give it the At command to disconnect. ATH is the syntax I believe.

------------------
"As hard as a rock & dumb as a brick"...Windows CEMeNT

4thandgoal
02-19-2001, 03:57 PM
Thanks Randy, I will try that.