knsksuresh
02-19-2001, 10:00 AM
The PC will not startup for some reasons and give beep sound. The beep sound is Long beep followed by a short gap and long beep this beep continues till the PC is turned off( even the power on switch will not work under this condition. The only way to overcome this is do not turn on the PC atleast for a week, if you try switching on the PC after a week most of the time it boot up and you can work normally. Once you shut down you cannot turn it on again atleast for a week.
I have tried changing the DRAM, Video CArd, SMPS power supply, there was no change in the status, THe configuration of the PC is given below,
Can you suggest some solution for the above problem,
- Intel PIII - 450 mhz
- Intel ZX Chipset Motherboard
- 64 MB SDRAM PC100 exp.
- 8.4 GB Ultra DMA Hard disk drive
- 8 MB AGP SVGA display card
- Dynalink 56K modem PCI
- Philips 5 x DVD drive
- Sound Card
BIOS - AWARD 1998
Rev : V4.51 PG
HDD Make - Seagate, Singapore
Seagate U4 Model ST 38421 A ( 8.4 G bytes)
16368 Cylinders, 16 heads, 63 Sectors
CHS - 16, 498, 944
DVD ROM DRIVE Make Philips, J
Model No: PCA 532
FDD 1.44MB, 3.5"
AGP CARD 6326
I have tried changing the DRAM, Video CArd, SMPS power supply, there was no change in the status, THe configuration of the PC is given below,
Can you suggest some solution for the above problem,
- Intel PIII - 450 mhz
- Intel ZX Chipset Motherboard
- 64 MB SDRAM PC100 exp.
- 8.4 GB Ultra DMA Hard disk drive
- 8 MB AGP SVGA display card
- Dynalink 56K modem PCI
- Philips 5 x DVD drive
- Sound Card
BIOS - AWARD 1998
Rev : V4.51 PG
HDD Make - Seagate, Singapore
Seagate U4 Model ST 38421 A ( 8.4 G bytes)
16368 Cylinders, 16 heads, 63 Sectors
CHS - 16, 498, 944
DVD ROM DRIVE Make Philips, J
Model No: PCA 532
FDD 1.44MB, 3.5"
AGP CARD 6326