PDA

View Full Version : Two stop error codes!


stryker115
05-15-2003, 06:19 PM
I just moved my computer yesterday, and attached it to the router in the new house. However, it was not getting an IP address from the router correctly, so I was messing around a bit, and after rebooting it again, I got the BSoD. It gave me Stop 0x51, REGISTRY_ERROR, and told me to remove any new hardware. I could not boot into safe mode, or even the command prompt, so I had to go into the recovery console and restore an old registry from several months ago.

Now, I get Stop 0x50 PAGE_FAULT_IN_NONPAGED_AREA when I start the computer. I can boot into Safe Mode now, but nothing I do gets rid of this new error. I tried removing the display adapter's drivers, removing my network card completely, but it's still there. What can I do?

Paul Komski
05-15-2003, 07:00 PM
Try re-seating your RAM

And here's a link:
http://www.microsoft.com/technet/prodtechnol/winxppro/reskit/prmd_stp_ccgm.asp