Vlan

[Zoran-Tarzan]

Can I set one (switch cisco 4006 ) switch port to bellong on two VLAN's?

[Ghost_Hacker]

No, a port can only belong to one VLAN.
You can use vlan trunking or multilayer switching ( which I think the 4006 can do) to forward data between VLANs if that's what your try to do.


However, there may be some advance setting I don't know about, so don't take my answer as the last one on the subject. :)

Hope this helps :)

[Zoran-Tarzan]

I saw (in cisco works) that there is an option to setup secondary VLAN, but I wasn't shure what is it. When I try to put VLAN number I receive message that "VLAN 4 is not a secondary VLAN"

[Ghost_Hacker]

Ahhh...community VLANs is a setting supported only by some of Cisco switches.


Look here to see if your switch supports the type of Private VLAN your interested in using and the instructions for setting it up:

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a0080094830.shtml


Good Luck :)