mb Probe

[Vic 970]

I have mb probe in my tool kit, it seems that it has set itself up from the sensors on my system. however in the past I ran it whilst I was trying to find where all my cpu usage was going (still dont Know) & the buzzer went off & it was showing 42*. didnt use it for a while after, but did yesterday whilst cpu was at 100% & mb warning went off & was showing 51.7*

currently mb is 35. CPU is 30. & aux 1 is 20.

is anybody using mb probe ?

what temps should I be looking for?

amd duron 750
K7VZA mb.

[Budfred]

Assuming that you are talking about Centigrade, those are quite respectable temps. If you are talking about Fahrenheit, they are amazing!!:D The 51C is a touch high, but not enough to worry about. Run it at that temp for a couple of years and it might reduce the life of your CPU a bit. Basically anything under 50C is going to be ok. There are several recent threads about temps, you might want to check them out if you want more detail...

[Vic 970]

thanks budfred

there is user adjustment for warnings within the prog, it is defaulted at 40* I will have a look at the other posts then set it a bit higher.(50)

I dont run it much but its nice to check now and again (providing u know what your looking for)

[Rick]

Set the cpu warning to 55c ( Safe at that temp)
Then set the others to 5/10c above normal running temps.

[Vic 970]

thanx both for the replies. I have set them accordingly.