saumil
09-28-2001, 07:24 PM
hello everyone,
I got cable connetion working from yestarday, so I wanted to share that cable connetion with another computer.. so i opened my computer and setup up new 3com enthernet card.. i didn't change anything in except that one. i fix the cable back at the back side back to normal but when i press power switch computer didn't respond at all. i opened the case and make sure everything was connected properly..but got same result.. so i pulled everything from the motherboard and put them back again.. but same thing.
here are some info about my hardware...
pentium III 450 processor
440 chipset
inc. on processor
393 MB RAM
on board I/O Board
8 MB AGP 3d accel.
. in short.. nothing happens when i turn on my computer on.. i mean when i push my powerbutton switch.. plz help.. pls tell me if my motherboard is damaged or the powercode?
thanks
[This message has been edited by saumil (edited 09-28-2001).]
I got cable connetion working from yestarday, so I wanted to share that cable connetion with another computer.. so i opened my computer and setup up new 3com enthernet card.. i didn't change anything in except that one. i fix the cable back at the back side back to normal but when i press power switch computer didn't respond at all. i opened the case and make sure everything was connected properly..but got same result.. so i pulled everything from the motherboard and put them back again.. but same thing.
here are some info about my hardware...
pentium III 450 processor
440 chipset
inc. on processor
393 MB RAM
on board I/O Board
8 MB AGP 3d accel.
. in short.. nothing happens when i turn on my computer on.. i mean when i push my powerbutton switch.. plz help.. pls tell me if my motherboard is damaged or the powercode?
thanks
[This message has been edited by saumil (edited 09-28-2001).]