GuinnessGuy74
05-23-2006, 11:52 AM
I am building a new system with a Biostar NF4SLI 939 Motherboard, Athlon64 3700+ and 2 Gigs Corsair XMS. I have a problem and I was wondering if any of you had any answers.
The motherboard will boot up fine. But after any reset (i.e. CTRL-ALT-DEL, reset button, saving changes and exiting after CMOS setup, etc), it will not boot up. The only way to get it to boot after this happens is to shut off the power switch in the back, and wait about 2-3 mins. It will then boot up fine. If I try to turn the power on any sooner than that it wont boot.
Any suggestions? I appreciate any input.......
Thanks,
Jim
The motherboard will boot up fine. But after any reset (i.e. CTRL-ALT-DEL, reset button, saving changes and exiting after CMOS setup, etc), it will not boot up. The only way to get it to boot after this happens is to shut off the power switch in the back, and wait about 2-3 mins. It will then boot up fine. If I try to turn the power on any sooner than that it wont boot.
Any suggestions? I appreciate any input.......
Thanks,
Jim