Greg Peterson
06-03-2006, 12:20 AM
Set up is as follows:
Motorola Surfboard cable modem >>
Motorola VT1000 voice terminal adapter (this is for Vonage, but it's also a
router)>>
SMC GS8 gigabit switch >>
2 computers connected to switch via Ethernet (work fine)
and D-Link DI-524 wireless G router connected to switch.
The purpose of the D-Link is to provide wireless access to my network and to the Internet.
I cannot view the setup page of the D-Link router from any computer.
However, if I connect a computer directly to a (vacant) port on the D-Link
router, then I can access the set up page (192.168....). However, I still do not have any Internet access from that computer.
Questions: How should I configure the D-Link wireless router? With a static IP address? Any sort of special settings I need to keep in mind?
Thanks in advance,
-G
Motorola Surfboard cable modem >>
Motorola VT1000 voice terminal adapter (this is for Vonage, but it's also a
router)>>
SMC GS8 gigabit switch >>
2 computers connected to switch via Ethernet (work fine)
and D-Link DI-524 wireless G router connected to switch.
The purpose of the D-Link is to provide wireless access to my network and to the Internet.
I cannot view the setup page of the D-Link router from any computer.
However, if I connect a computer directly to a (vacant) port on the D-Link
router, then I can access the set up page (192.168....). However, I still do not have any Internet access from that computer.
Questions: How should I configure the D-Link wireless router? With a static IP address? Any sort of special settings I need to keep in mind?
Thanks in advance,
-G