tbowen
12-10-2007, 04:35 PM
OK, so I noticed this morning I had no internet. I have a direct cable from our Linksys WRT45G to my computer. The router's power and Diag lights were blinking. Apparently this means the firmware needs to be upgraded. I know it's not my provider, cause when I plug directly into the cable modem, it works fine. So I downloaded the upgrade from linksys and when I try to go to the router setup page to upgrade, it won't load the page. I tried 192.168.1.1, I think, whatever the default it. And it won't load. So then I downloaded the 'tftp.exe' from linksys to try and upgrade it using that, and it won't upgrade. Any ideas? Thanks.