Gunther
12-24-2000, 05:08 PM
My Win98 Pentium includes an Adaptec 2930U SCSI board which runs my SCSI
back-up hard drive. The SCSI HDD runs and was set up with EZ-SCSI 5.0.
I then wanted to attach my old 450MB SCSI back-up from my 486 which ran under EZ-SCSI 3.12 with an ADAPTEC 1522A board.
The Pentium system would not recognize the old 450MB SCSI HDD.
Can anyone tell me why and how I could rectify this?
I would like to use the content of the old 450MB SCSI drive which has DOS
6.2 and Win 3.1 on it to run two DOS6.2 programs.
Thanks for any suggestions.
Gunther
mail to: Gunther-Steinberg-PV@worldnet.att.net
back-up hard drive. The SCSI HDD runs and was set up with EZ-SCSI 5.0.
I then wanted to attach my old 450MB SCSI back-up from my 486 which ran under EZ-SCSI 3.12 with an ADAPTEC 1522A board.
The Pentium system would not recognize the old 450MB SCSI HDD.
Can anyone tell me why and how I could rectify this?
I would like to use the content of the old 450MB SCSI drive which has DOS
6.2 and Win 3.1 on it to run two DOS6.2 programs.
Thanks for any suggestions.
Gunther
mail to: Gunther-Steinberg-PV@worldnet.att.net